Instructions:
Homax
Popcorn Ceiling Texture is designed for repairing popcorn ceiling
textures or applying new texture to your ceiling. After making any
necessary wall repairs, just spray on texture, allow to dry and paint
if necessary to blend with surrounding surface.
IMPORTANT:
This aerosol can discharges material very rapidly. Follow instructions
carefully for proper results. DO NOT spray sideways or upside down. Eye
protection recommended.
WARM CAN TO ROOM
TEMPERATURE BEFORE USE. Prep surface properly before applying. Use
putty knife to scrape away stained or damaged texture. Apply white
primer/sealer before applying.
- Protect carpet, furniture and entire area from overspray.
TIP: Pin up a plastic drape or hold a box around patch area to contain overspray. - Shake can vigorously for one minute until mixing ball rattles. Screw nozzle onto valve stem.
- Place fingers on each side of spray nozzle and hold approximately 9 to 14” from ceiling.
TO SPRAY: Pull spray nozzle completely down in short bursts while sweeping spray across surface.
TIPS:
Apply generously around patch, feathering spray into existing texture.
Do not apply too heavily or texture will sag.
For a heavier “chip” texture, apply multiple thin coats, allowing texture to dry slightly between applications.
If painting over texture is desired, allow to dry for 24 hours before painting.
Clean up with warm water.
Covers approximately 6 sq. ft.