DAP Concrete Bonding Additive

Description

DAP Concrete Bonding Additive is an advance vinyl compound that can be used to create a high moisture resistant, high-density concrete. DAP Concrete Bonding Additive is perfect for new to old concrete patching, resurfacing and leveling. It is excellent for capping walls, patching steps and tuck pointing.

• Color: White
• Sheen: Smooth
• Product Type: Crack Stabilizing Primer
• Container Size: 1 gal
• Full Cure Time: 24 hr
• Recommended Surface: Concrete/Masonry
• Indoor or Outdoor: Indoor and Outdoor
• Odor Level: Low Odor
• Clean Up: Water
• Coverage Area: 350 sq ft
• Time Before Recoating: 45 min
• Tintable: No
• Stain Blocking: No
• Primer and mix in one
• Super durable
• Multi-use

Extended Information

Surface Preparation & Application:

Estimated Coverage:
Quart: Will prime and patch area plus reinforce two 60 lb. sacks of dry-mix concrete.

Gallon: Allow 1 gallon adhesive per sack of pure dry cement or 1 to 1-1/2 gallon adhesive per 500 lb. of

cement mix.

Admix Solution:

Prepare by making a solution of 1 measure of additive added to 4 measures of clean water.

Mortar Mix:

Use packaged dry “Topping Mix” or 1 measure of Portland Cement mixed with 4 measures of sharp, clean

sand. Add enough Admix Solution to the dry mix to form a stiff mortar. Thin wet mixes cause shrinkage and

cracking.

Patching Concrete Steps, Curbs or Joining New Concrete:

Remove all dirt, paint, wax, and loose material from surface to be patched. Prime coat the surface to be
patched with undiluted Concrete Bonding Additive.  When the prime coat is tacky, apply fresh mortar
which has been made using the Admix Solution. Do not allow the prime coat to dry out. If the prime coat
does dry out, apply a second coating of the Concrete Bonding Additive and repair immediately.

Tuck Pointing:

For an extra strong mortar for brick, applying wall caps, tuck pointing and filling cracks, use a Mortar Mix as

described above.

Resurfacing Walls and Floors:

• Remove all wax, dirt and loose paint from concrete area to be resurfaced. Scrub the concrete surface with a

10% solution of muriatic acid and wash away with clean water. Let dry.

• Test for bond: Traces of silicates, silicones, etc., used for sealing and waterproofing, may prevent a bond of

new material. Make a test patch before proceeding.

• Prime with a mixture of 4 parts Bonding Additive mixed with 1 part clean water. Use an extra prime coat

on all areas where new concrete will be feather edged.

• Wet the cement/sand mix with a solution of 1 part Bonding Additive mixed with 4 parts clean water.

Note: Concrete Bonding Additive is not considered compatible with: Glue sizings, wallpaper paste,

paraffin oils, waxes or vinyl chloride.

Color: White

Consistency: Smooth

Temperature Application Range: Above 50ºF

Bond Strength: High

Dry Time: 45 min., depending on temp. & humidity

Freeze/Thaw Stability: Passes 5 Cycles

Coverage: Approx. 350 sq. ft./gallon

Shelf Life: 1 Year Minimum

Viscosity: 1500 – 1900 cps

Storage: At room temperature between 40-80ºF

Clean Up:

Before setting, remove excess additive with a damp cloth. Dried additive must be cut or scraped away.