Rust-Oleum Plastic Primer Spray

Description

Rust-Oleum Specialty Plastic Primer Spray prepares plastic for painting with any top coat. Apply directly to plastic mailboxes, lawn chairs, storage lockers and more. Adheres to hard-to-paint surfaces.

PRODUCT FEATURES:

• Adheres to hard-to-paint surfaces
• Renew or change the color of plastic items around the home
• Choose from a variety of top coat colors.  

This Item Can NOT Be Shipped Internationally

Extended Information

PAINTING CONDITIONS

Use outdoors or in a well ventilated area such as an open

garage. Use when temperature is between 50ºF (10ºC) and

90ºF (32ºC) and humidity is below 65% to ensure proper

drying. Avoid spraying in very windy and dusty conditions.

Cover surrounding area to protect from spray mist.

SURFACE PREPARATION

For new plastic surfaces, thoroughly wipe down surface with

paint thinner to promote adhesion. For aged or weathered

surfaces, remove loose material with a brush or scraper, clean

with soap and water, rinse and let dry. Sanding may be required

for glossy or smooth surfaces. If mildew is present, wash with a

bleach solution, rinse and let dry.

APPLICATION

Shake can vigorously for one minute after the mixing ball

begins to rattle. If mixing ball fails to rattle DO NOT STRIKE

CAN. Contact Rust-Oleum. Shake often during use. Hold can

upright 10-16” from surface and spray in a steady back-

and-forth motion, slightly overlapping each stroke. Keep the

can the same distance from the surface and in motion while

spraying. For best adhesion, apply one THIN coat and not a
heavy coat or multiple coats. Do not use near open flame.

DRY and RECOAT TIMES

Dry and recoat times are based on 70ºF and 50% relative

humidity. Allow more time at cooler temperatures. Dries to touch

in 20-30 minutes, to handle in 1 hour and fully dry in 24 hours.

Apply any Rust-Oleum finish coat after 1 hour. Maximum

adhesion is achieved in 5-7 days.

CLEAN-UP

When finished spraying, clear spray valve by turning the can

upside down and pushing the nozzle for 5 seconds. Clean-up

wet paint with xylene or mineral spirits. Properly discard empty

container. Do not burn or place in home trash compactor.

CLOGGING

If the valve clogs, twist and pull off spray tip and rinse in a solvent

such as mineral spirits. Do not insert any object into can valve

opening.