XIM UMA Primer Sealer Bonder

Description

UMA’s advanced technology has both primer and adhesive-like properties.  A quick drying, white bonding primer / sealer that provides excellent adhesion. Can be tinted. for tough-to-paint surfaces: glass, tile, Formica, metals, many plastics, wood and other construction materials including Kynar® and silicone polyester pre-coated siding.

• Accepts all topcoats
• Bonds / seals to hard-to-paint surfaces
• Excellent wet adhesion
• Low VOC, low odour
• Interior / Exterior

FOR BEST RESULTS

Surface must be clean and dry, free from all grease, wax, oil, polish, loose paint, dirt, rust or other contamination.

XIM UMA White Technical Data Sheet

XIM UMA White Spray Technical Data Sheet

Coverage	Brush On: 200-400 sq ft per gallon (depending on type and condition of surface) Aerosol: 10-12 sq ft per can
Dry to Touch	30-45 minutes
Dry to Topcoat	3 Hours
Full Cure	Brush On: 7-10 Days Aerosol: 24 Hours
Clean Up	Soap and Water

Extended Information

Product Preparation:

Advanced Technology UMA is ready to apply from the can. If tinting,

use universal tinting colors. Do not exceed two (2) ounces of tint

per gallon. Shake or mix well before using.

Surface Preparation:

Surface must be clean and dry, free from all grease, wax, oil, polish,
loose paint, dirt, rust or other contamination. Clean with a strong
abrasive detergent, rinse well and allow to dry.

Scrub moldy or mildewed surfaces with bleach and rinse well.

When priming hard, glossy surfaces,

metal or pre-finished siding clean per SSPC-SP1, which is sol

vent cleaning. Wipe down the surface with

XIM GON Cleaner or Xylene. Do not use mineral spirits,
turpentine solvents that will leave oily

residues. For very hard, glossy surfaces, roughing the surface
with silicon carbide sandpaper before

applying the Bonder necessary for best adhesion.

How to Apply:

Apply this Bonder by synthetic fiber brush, ¼ inch synthetic roller

or by spray. Avoid any excess foaming by thoroughly wetting the

brush or roller with water before applying. The temperature of the
surface and the surrounding air should be between 35 deg. F and 100 deg. F. .
It will dry to touch in about 30-45 minutes under standard conditions
(77 deg. F and 50% relative humidity). Thicker coats will take longer

to dry. It will generally become hard in about 7 - 10 days. They can be top-coat

ed in 3 hours after application. When top coating with 2-component paints allow 24

hours before painting. Do not paint in direct sun or on a hot surface. Stop application
two hours before a heavy dew or rain. If possible plan your

painting to avoid rain, moisture and high humidity for the first 24 hours of curing.
Advanced Technology covers about 450 square feet per gallon.

Caulk seams and edges after priming.

Clean-Up:

Clean-up with soap and water. If the UMA “sets-up”, or when cleaning up splatters or
spills use warm water or lacquer thinner.