Cabot Australian Timber Oil - VOC Water Reducible Oil Modified Resin

Cabot Australian Timber Oil® is a unique blend of oils originally formulated to protect dense Australian tallowwood, cambara and merbau from extreme exposures. It is a proven translucent oil treatment specially formulated for decks and outdoor furniture. Penetrates deep into woods to accentuate natural wood depth and patina.

Containing a precise blend of superb-grade linseed oil for maximum penetration, long-oil alkyds for durability and pure tung oil for color depth and water repellency, Cabot Australian Timber Oil® delivers three-way oil protection. Complex translucent iron-oxide pigments are added to ensure lasting, UV-absorbing surface rich with color and dimension.

This product is in compliance with Federal VOC (Volatile Organic Compounds) requirements for Specialty Architectural Coatings under current regulations. Recommended for use on: exterior wood decks, siding, railing, steps and fences as well as exterior furniture.

Coverage
On smooth surfaces, approximately 250-350 square feet per gallon; on rough surfaces, 100-200 square feet per gallon. These rates will vary depending upon the porosity of the surface.



Preparing Your Surfaces
Proper surface preparation is the key to maximum finish performance. The durability of this product can be impaired by an unsound or poorly prepared surface. It is very important the surface be clean of all dirt, mildew stains, loose wood fibers and other foreign matter. Surfaces must be structurally sound and absolutely dry. (Moisture content must be below 15%, or the wood must be exposed to dry weather for a minimum of 3 to 5 days.) Use Cabot Problem-Solver® Wood Cleaner and a stiff bristle brush or power wash to remove the surface layer of all loose wood fibers, dirt, mildew stains and other foreign matter. For new and weathered wood surfaces, a light sanding with 80-100 grit sandpaper is recommended to open the pores for maximum penetration. Use Cabot Problem-Solver Wood Stripper #8004 or #8005 to help remove oil-based finishes from wood surfaces. Use Cabot Problem-Solver Wood Brightener to easily remove tannic acid (extractive) bleeding, nail and metal rust stains, and renew the wood's appearance. Most woods will require sanding after the use of Problem-Solver Wood Cleaner and Wood Stripper. Also, some woods may turn darker in color when using Problem-Solver Wood Stripper.

Application
Optimal results can be obtained by using a pure lambswool applicator, although a high-quality, natural bristle brush also yields excellent results. When spraying Cabot Australian Timber Oil for Decks and Outdoor Furniture, immediately backbrush after each section is coated to ensure proper penetration. To avoid lap marks, start at one edge and follow through to the end of the boards. Apply Cabot Australian Timber Oil for Decks and Outdoor Furniture to small sections at a time, 2-3 boards at a time. Product that does not penetrate must be removed or rubbed into the boards parallel to the wood grain. For outdoor furniture: Best results can be achieved by hand rubbing the finish into the wood grain by using a soft cloth or lambswool applicator.

Cleanup and Disposal