Old Masters Professional Fast Dry Wood Stain - Quart

Old Masters Fast Dry Wood Stain is a high-caliber alkyd stain designed for the professional craftsman who values speed, versatility and performance.

This stain’s heavy consistency provides ease of application and achieves warm, rich colors in one coat. Its formulation allows the color to flow easily onto the surface and penetrate deep into the wood’s natural grain. Within minutes of the stain’s application, you can apply virtually any finish.

This product is ideal on all interior wood surfaces, such as cabinets, doors, furniture, floors and woodwork. Be assured that your finished project will possess the timeless beauty and durability you would expect from an Old Masters product.

Old Masters Fast Dry Wood Stain Technical Data Sheet

Product Data Sheet

Coverage	500 sq ft per gallon (depending on condition of wood)
Dry Time	30 Minutes
Clean Up	Solvent

Where to Use
Experience optimal results on all interior wood surfaces, such as cabinets, doors, floors, furniture, and woodwork.
Surface Preparation
The wood surface must be clean, dry, and free from dirt, wax, or grease. Sand the wood thoroughly - first with medium grit sandpaper, then progressing to a fine grit paper. Always sand in the direction of the wood grain. Sand smooth, then remove dust particles with a lint-free rag or a tack rag. If staining previously finished surfaces, first restore the surface to bare wood by completely removing the old finish, then follow the surface preparation directions listed above.

Application
Stir well before and during use. Stain may be brushed, sprayed, or wiped onto the surface. Before the stain dries, wipe off excess stain with a soft cloth. Allow stain to dry thoroughly before applying topcoat.

Technical Information

Mixing and Tinting:
Achieve custom colors by intermixing Fast Dry Wood Stain colors or by adding up to 10 ounces of universal or industrial colorant per gallon to any Fast Dry Wood Stain or by adding colorant to Natural/Tint Base Fast Dry Wood Stain. Natural/Tint Base Fast Dry Wood Stain may be used to lighten a Fast Dry Wood Stain color in any proportion or as a tint base to which colorant may be added for ultimate color selection. The amount of colorant added may affect performance and extend dry time.

Coverage:
Approximately 500 square feet per gallon. Spreading rate will vary significantly depending on application method and condition of wood.

Drying Time:
Oil-based finishes may be applied 30 minutes after wiping. Dry times may be extended due to humidity, low temperature, lack of air movement, excess stain application, or lack of penetration. Be sure surface is thoroughly dry before top coating. Ideal drying conditions recommended are 70° to 75°F and 35 to 50% humidity.

Cleanup:
Using a cleaning solvent, such as paint thinner or mineral spirits, is recommended for cleanup. The use of paint thinners or mineral spirits may violate VOC compliancy in your area. Check with your local government agencies to ensure proper compliancy.

DANGER: Rags, steel wool, sanding residue, and other wastes used or soaked with this product may spontaneously catch fire if improperly discarded. No ignition source is required for these wastes to start on fire by themselves. Immediately place rags, steel wool, sanding residue, and other wastes used or soaked with this product in a sealed, water-filled metal container. Dispose of in accordance with local fire regulations.
Recommended Finish Coat:
We recommend Old Masters clear finishes. However, Fast Dry Wood Stain can be top coated with virtually any finish, including professional finishes such as lacquers and conversion varnishes. Wait 24 hours before top coating with a water-based clear finish.
EPA VOC: 550 g/L (4.5 lbs/gal)
Actual VOC: 550 g/L (4.5 lbs/gal)